Installment and Debugging of Specific-gravity Stoner

Writer： admin Time：2020-07-09 17:36 Browse：℃

Installment and Debugging of Specific-gravity Stoner
1. Preparation and inspection before using.
installment sequence:
1. Check whether the size of the basic position is correct;
2. Position the machine and keep it level;
3. The main body of the equipment is in place;
4. Find a professional electrician to connect the power cord and check positive inversion of motor.
2. Operating procedures, methods, attentions, and erroneous operation and precautions during startup and operation.
1. The mobile device should ensure a slow and balanced speed.
2. Install electrical protection devices.
3. Check whether the transmission part is loose or falling off.
4. Check whether there is foreign matter in the main fan.
5. Check the direction of fan operation.
6. Check whether the motor screw is loose.
7. Check whether the protective cover is installed, and it is strictly forbidden to run the machine without the protective cover.
3. Operation procedures, methods and attentions for shutdown
1. Turn off the power supply of the stone removal machine.
   2. Turn off the power system.
4. Debugging method
1. Place the stone removal machine horizontally
2. Check the protective cover, electrical devices, and power supply
3. Find a professional electrician to connect the power supply and check the positive inversion of the motor
4. If the two electric reversals, please refer to the motor wiring manual
5. Working order
Pour the raw materials into the hopper, turn on the power of the equipment and feed control switch, and adjust the speed of the feeding by adjusting the wire, from slow to fast. Adjust the butterfly-shaped adjusting wire above the outlet of stone according to the stone content in the raw material and the size of the stone. It is downwards for open and upwards for close.
Check whether the raw materials on the countertop are full. Based on the center of the specific gravity platform, the material thickness is 45 ~ 60 mm. The net material accounts for one-fifth of the countertop and is about 100 mm long (from raw material outlet).